iSTAR Pulsar status LEDs
While uploading data, iSTAR Pulsar will display a solid Green system LED, and a pulsing Blue Wi-Fi LED:
Once all queued captures have been uploaded, the device will return to "Ready" status, showing two solid Green LEDs.
iSTAR Pulsar Mobile App
When a user commences uploading data from iSTAR Pulsar to VR.World by moving the mode switch to the Left, the unit immediately ceases emitting a Wi-Fi signal and connects to the Wi-Fi network that the user specified. As such, the mobile app/device will disconnect completely from iSTAR Pulsar after a few minutes:
Users can however at this point connect their mobile device to the same Wi-Fi network that iSTAR Pulsar is using to upload data - with both devices connected to the same network, the mobile app will re-connect with the device, and users can observe the progress of their uploads within the capture manager page:
From top to bottom, the above captures are:
- Queued for upload, this capture will upload once the current one completes
- Currently uploading, approx 23% complete as shown
- Already uploaded to VR.World
VR.World
When a capture begins uploading, it will also appear under the "Uploading" tab within VR.World with a white tab to the left indicating that the upload is in progress:
Clicking/tapping on the capture will display additional detail, at this stage only the below is available:
Once the upload of the capture is complete, the tab to the left of it will turn red, and preview generation will automatically begin:
When preview generation is completed, the capture will leave the "Uploading" tab, and users may browse to the "Preview" tab in order to preview the data.